Abstract
AlCrFeNiCu high-entropy alloy (HEA) coating was prepared on Zirconium (Zr) rod by high-speed laser cladding (HSLC) technique. The effect of different laser power and scanning speed on the forming quality of the coating was studied. When the specific energy density was in the range of 3.0–3.2 J/mm2, the AlCrFeNiCu HEA coating with good adhesion to the substrate, low dilution rate (small heat affected zone) and no cracks were obtained. The phase structure, microstructure, microhardness, corrosion resistance and high temperature oxidation resistance of the coating were tested and analyzed. The results show that the AlCrFeNiCu HEA coating is composed of 76.9 % BCC phase and 23.1 % FCC phase, in which the BCC phase is mainly composed of disordered BCC phase rich in Cr and Fe elements and ordered B2 phase rich in Al and Ni elements, and the FCC phase is rich in Cu elements. Due to the rapid cooling of HSLC, the coating structure gradually changes from columnar crystal to equiaxial crystal from bottom to top. The hardness of the coating is as high as 805 HV, which may be caused by the solution strengthening effect, lattice distortion effect and slow diffusion effect of HEA. In 3.5 % NaCl solution and 0.1 mol/L KOH solution, the self-corrosion current density of the coating is 4.209 × 10−8 A/cm2 and 4.331 × 10−8 A/cm2, respectively. The passivation film on the surface of the coating is composed of a variety of oxides, and the oxygen vacancy density of the passivation film in the two solutions is 2.552 × 1020 cm−3 and 5.794 × 1020 cm−3, with fewer pitting pits on the surface. The structural integrity of the coating can be maintained after 60 min oxidation at 1200 °C. The oxidation process follows the growth kinetics curve, and the surface oxides mainly comprise FeAl2O4, Al2O3 and Cr2O3. AlCrFeNiCu HEA coating improves the corrosion resistance and high temperature oxidation resistance of the Zr-4 alloy.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
