Abstract
AbstractSpecimens of two engineerig plastics i.e., poly(ether imide), PEI, and poly(2,6‐dimethyl‐ 1,4‐phenylene ether), PPE, were injection molded employing a 40t Van Dorn injection molding machine and industrial practices. The mold and melt temperatures and the injection speed were varied in a limited range which furnished acceptable samples. The density, birefringence, residual stress distributions, flexure and tensile properties, and crack development of the injection molded specimens were studied. Vacuum compression molded samples were also prepared to investigate the role played by the cooling rate in shaping microstructural distributions. The results revealed significant differences in the development of microstructure of the molded specimens of the two resins, which was related to rheology and molding conditions on one hand and to development of cracks and ultimate properties on the other hand.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
