Abstract
This paper aims to develop a surface modification process to improve the surface properties of the middle trough. The coatings were prepared by plasma cladding with Fe-Cr-B-Si-based alloy powders (Ig 6 and Ig7). The organizational structure and micro-hardness of the coatings were analyzed by laboratory equipments. The friction and wear tests were performed to investigate the friction-wear properties of middle trough. The coatings have higher hardness and good friction-wear properties than the substrate. The hardness and friction wear properties of the coating with Ig7 powder are better than those with Ig6 powder. The experimental results show that the surface properties of the middle trough are improved by Fe-Cr-B-Si-based alloy coating, which can improve the middle trough service life. The plasma cladding can be widely used in the surface-modification of middle trough to reduce the waste of resources.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Wuhan University of Technology-Mater. Sci. Ed.
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.