Abstract
In the paper, a Ni-base composite cladding was cladded on the surface of QAl9-4 aluminum bronze by laser cladding technology, as well as its microstructure and tribological properties are studied. The results show that the microstructure of laser cladding is affected by solidification rate, and its wear behavior mainly lies on microstructure and lubrication condition. The microstructure of laser cladding is made up of cellular crystal and dendrite crystal. The microstructure of the surface cladding is cellular crystal, the middle section is crassitude dendrite crystal, and the bottom is coarse dendrite crystal and cellular crystal. Under dry friction condition, wear mechanism is abrasive wear and shedding strengthen phase, which has higher volume’s wear rate. Under lubricate condition, wear mechanism is abrasive wear and adhere wear, which has lower volume’s wear rate than that of dry friction. The average friction coefficient of the cladding under dry and lubricate condition are 0.39 and 0.15, the volume’s wear rate are 7.88×10-8mm3/N.mm and 1.56×10-9mm3/ N.mm, respectively. Therefore, the cladding has favorable wear resistance property under lubricate condition,and can be used as an excellent wearable material.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.