Abstract
The Nb–12Si–22Ti–14Cr–2Al–2Hf alloy (at%) was directionally solidified at 1750°C with withdrawal rates of 0.24mm/min, 1.2mm/min, 6mm/min, 18mm/min, 30mm/min, 50mm/min, 70mm/min and 100mm/min, and subsequent heat treatment was carried out at 1375°C for 10h. The microstructures and room-temperature fracture toughness of the directionally solidified and heat treated samples were investigated. The results showed that instead of the microstructure consisting of NbSS dendrites, NbSS+Nb5Si3 eutectics and Cr2Nb+Ti-rich NbSS eutectics, the microstructure composed of NbSS dendrites, Nb3Si laths and Cr2Nb+Ti-rich NbSS eutectics was observed when the withdrawal rate was higher than 30mm/min. After the heat treatment, the Nb3Si transformed into extremely fine NbSS and Nb5Si3, and the NbSS dendrites changed to be remarkably continuous. The room-temperature fracture toughness could reach a maximum of 15.7MPa·m1/2 for the alloy withdrawn at 50mm/min plus heat treatment. It is suggested that the microstructure with fine intermetallic phases (Nb5Si3 and Cr2Nb) and continuous NbSS would be of great benefit to the room-temperature fracture toughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
