Abstract
Abstract In this paper, microstructure and some properties of various coatings based on WC-Co obtained by the High Velocity Air Fuel technique are discussed. Initially, two WC-Co 83-17 powders of standard and superfine size were examined as a feedstock for a coatings deposition on a steel substrate. A standard Amperit 526.074 powder and an Inframat superfine powder were applied. Then three different sub-micrometric powders, WC, Cr3C2 and TiC were applied to modify the microstructure of WC-Co (Amperit 526.074). The aim of the investigations was to compare the microstructure and basic properties of coatings deposited from different components. The influence of sub-micrometric additions on mechanical properties of basic coatings was analyzed. Microstructure characterization of powders by using SEM and characterization of their technological properties as well, are presented. For all manufactured coatings obtained by a High Velocity Air Fuel method, the microhardness, porosity, adhesion to a substrate, and fracture toughness were determined. An improvement in WC-Co coating properties, as a result of sub-micrometric carbides addition, was revealed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
