Year-end Sale % OFF 
Abstract
Blended elemental powder metallurgy using titanium hydride and Al–Fe–Cr master alloy powders was employed to produce a new Ti–1.5Al–1Fe–7.2Cr (wt.%) transition α + β/β metastable-type alloy. A simple process involving blending, cold pressing, and sintering resulted in a material with a residual porosity of not higher than 3.9–5%, a uniform and relatively fine-grained microstructure (average β-grain size of less than 100 μm), and acceptable mechanical properties. The influence of subsequent annealing and hot pressing on the microstructure evolution and porosity reduction was investigated. The results indicated that optimized regimes of hot deformation and heat treatment produced a structural state with a good combination of strength (UTS = 970 MPa) and ductility (El = 14.7%, RA = 35%).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
