Abstract
A mixture of Al, Ti, Cu, Ni, and Sn was used as the matrix material to fabricate diamond composites and grinding heads through self-propagating high-temperature synthesis (SHS). High-frequency induction was used as a heat source for preheating to ignite SHS. The SHS was examined, and the microstructure of the reaction products was analyzed by scanning electron microscopy and X-ray diffraction. As a comparison, diamond composites and grinding heads were fabricated by hot pressed sintering (HPS) using Cu-based matrix. The grinding performance of heads was tested in the grinding of Zirconia ceramics. Results showed that ferromagnetic Ni was a key element without which SHS could not start. Increasing frequency prolonged preheating time and decreased combustion temperature. The increasement of Al+Ti content in the matrix aggravated the combustion temperature and thereby aggravated the porosity. The optimal grinding ratios of SHS grinding heads was reached when Al+Ti weight content was 30% and was only 4% lower than that of HPS ones. The grinding forces of SHS grinding heads was lower than that of HPS ones. Carbides Ti3AlC and Ti3AlC2 formed on the diamond surface during SHS.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Refractory Metals and Hard Materials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
