Abstract
AbstractThe influence of different shear stresses induced by changing injection molding speeds on molecular chain orientation and lamellar branching of β‐nucleated iPP/poly(ethylene terephthalate) (PET) microparts was investigated using two‐dimensional wide‐angle X‐ray diffraction and 2D‐small‐angle X‐ray scattering. Results indicated that the prevailing shear stress can promote the formation of parent–daughter α‐crystal structure and twisted shish–kebab structure in subsequent microparts. The diffraction of (300) plane of β‐crystals was also observed at varying injection speeds. Increasing injection speeds can significantly enhance the content of β‐crystals from 24 to 41% for β‐nucleated iPP microparts. Additionally, the content of β‐crystals was further enhanced in β‐nucleated iPP/PET microparts with in situ formation of PET microfibrils under intensive shearing conditions. The addition of both PET and β‐nucleation agents coupling with high shearing conditions exerts a synergetic effect on the development of β‐crystals. However, the orientation degree of crystal lattice decreased with increasing injection speeds for both β‐nucleated iPP and iPP/PET microparts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
