Abstract
AbstractA surface texture consisting of an array of holes in SiC components was obtained by either conventional molding in the green state or post sintering laser machining. According to microstructural analysis, very regular holes were obtained by laser machining with minimal microstructural damage. Irregular holes with defects and voids were instead found for the surface textures obtained via molding. Nanoindentation tests were performed in the areas close to the holes and no significant alteration of the mechanical properties was found after laser machining.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
