Abstract
Tungsten fiber reinforced tungsten composites were fabricated by Fe activated sintering. The effect of Fe content (0.5% ∼ 1.0%(wt%)) and original fiber volume fraction (10% ∼ 50%(vol%)) on relative density, microstructure and mechanical properties were studied. The interaction between the Fe and tungsten fiber was analyzed. The fracture behavior as well as the strengthening and toughening mechanisms were revealed. The results indicated that the Fe not only promoted the sintering densification of the tungsten matrix, but also caused the recrystallization of tungsten fiber from the surface to the center due to the element diffusion. The (i) relative density, (ii) residual fiber diameter (or residual fiber volume fraction) and (iii) flexural strength were (i) increased, (ii) decreased and (iii) increased with Fe content increased, respectively, while were (i) decreased, and (ii, iii) first increased and then decreased with the original fiber volume fraction increased, respectively. As for the composites containing 1.0%Fe, the fracture toughness was monotonically increased with the increase of the original fiber volume fraction. The fracture mode of the matrix was intergranular. The strength and toughness of the composites were enhanced as a result of fiber fracture, crack deflection, interface debonding, and fiber pull-out.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Refractory Metals and Hard Materials
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
