Microstructure and mechanical properties of transient liquid phase bonding DD5 single-crystal superalloy to CrCoNi-based medium-entropy alloy

Abstract

• The transient liquid phase bonding of DD5 single-crystal superalloy to CrCoNi-based medium-entropy alloy was achieved using a BNi-2 filler interlayer. • The M5B3-type boride (BCT) precipitated in the diffusion-affected zone exhibiting a coherent relationship of [ 2 4 0]BCT // [0 1 1]FCC and (0 0 2)BCT // (2 0 0)FCC with the FCC matrix. • The effect of the reaction phase properties on the joint performance was investigated. • The maximum shear strength of 752 MPa was obtained with the eutectic-free joint. This study focuses on the transient liquid phase (TLP) bonding of DD5 single-crystal superalloy to CrCoNi-based medium-entropy alloy (MEA) using a BNi-2 filler alloy. The microstructure and mechanical properties of the TLP-bonded DD5/MEA joint were evaluated, and the microstructural evolution mechanism was investigated. The formation of the isothermal solidification zone (ISZ) depended on the diffusion of the melting-point depressants (Si and B elements) from the liquid filler into the DD5 and MEA substrates, as well as the dissolution of the substrates. Boron diffused along the γ channel of DD5 and reacted to form M 5 B 3 boride, herein referred to as the diffusion-affected zone (DAZ I). Similarly, the Cr 5 B 3 boride precipitated in the Ni-rich MEA matrix adjacent to the MEA substrate (i.e., DAZ II). Additionally, a coherent orientation of [0] BCT // [0 1 1] FCC and (0 0 2) BCT // (2 0 0) FCC was detected between M 5 B 3 boride with a body-centered tetragonal (BCT) structure and the face-centered cubic (FCC) matrix. The performance of the joint was dominated by the properties of the bonding seam. As the bonding time increased from 20 to 80 min, the athermal solidification zone (including eutectic microstructure) was gradually replaced by the ISZ exhibiting excellent plastic deformation capability, and the shear strength of the joint was improved. The maximum shear strength (752 MPa) was achieved when the eutectic-free joint was bonded at 1050 °C for 80 min. The fracture morphology revealed a mixture mode, indicating the initiation of cracks in the DAZ II, mainly propagating in the ISZ, and passing through the DAZ I.