Abstract
AbstractIn this study, fully densified Si3N4/TiAl composites were fabricated using the field-assisted sintering technique (FAST). Microstructural analysis showed the evolution of a continuous network structure consisting of minor fractions of in-situ formed Ti2AlN, unreacted Si3N4 ceramic particles and dominant Ti5Si3 intermetallic phases within the TiAl matrix at Si3N4 content above 1.5 wt%. The hardness of the developed composites increases with increasing Si3N4 content, with 7Si3N4/TiAl composite exhibiting the highest hardness of approximately 487 HV1.0, which was about 57% higher than that of the sintered pure TiAl alloy. Among the sintered samples, 1.5Si3N4/TiAl composite displayed the highest flexural strength of 832.65 ± 12.88 MPa (34.3% higher than pure TiAl matrix) with a deflection of 0.14 mm. In contrast, the lowest flexural strength and deflection of 535.44 ± 21.14 MPa and 0.09 mm were obtained in composite reinforced with 7 wt% Si3N4 ceramic content. The fractured surface of the sintered samples displayed predominantly cleavage fracture mode.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
