Microstructure and mechanical properties of modified and non-modified stir-cast Al-Si hypoeutectic alloys

Abstract

The microstructure and mechanical properties of modified and non-modified stir-cast commercial aluminium alloys A-S7G03 and A-S4G have been investigated. Stir casting of these alloys resulted in spherical and/or rosette shape primary α-phase, and the eutectic silicon was broken into miniature needle morphology. This stir-cast structure slightly improved the mechanical properties in comparison to those of conventionally cast alloys, however the fracture of the stir-cast alloys revealed intergranular brittle fracture. The addition of 0.02% strontium, in the form of Al-5 mass% Sr master alloy, during stir casting modified the eutectic silicon into a very fine spheroidal morphology, while the α-phase particle showed the same morphology as the stir-cast alloys. This novel structure resulted in significant improvement of mechanical properties. The elongation of the modified stir-cast alloys was five times greater than that of the non-modified one. A transgranular mode of fracture was observed for the modified stircast alloys, moreover smooth ripple and dimple patterns were observed reflecting the high ductility of the modified stir-cast alloys.