Microstructure and mechanical properties of laser welded dissimilar DP600/DP980 dual-phase steel joints

Abstract

The use of dual phase (DP) steels in the automobile industry unavoidably involves welding and dynamic loading. The aim of this investigation was to evaluate the microstructural change and mechanical properties of laser welded dissimilar DP600/DP980 steel joints. The dissimilar joints showed a significant microstructural change from nearly full martensite in the fusion zone (FZ) to the unchanged ferrite–martensite dual-phase microstructure in the base metal. The welding resulted in a significant hardness increase in the FZ but the formation of a soft zone in the heat-affected zone (HAZ). The dissimilar welded joints were observed to exhibit a distinctive unsymmetrical hardness profile, yield-point-like phenomenon, and single-stage work hardening characteristic, with yield strength and work hardening rate lying in-between those of DP600 and DP980 base metals, and ultimate tensile strength equivalent to that of DP600 base metal. Although the welded joints showed a lower fatigue limit than the base metals, the fatigue life of the welded joints at higher stress amplitudes was almost the same as that of the DP600 base metal. The welded joints failed in the soft zone at the DP600 side under tensile loading and fatigue loading at the higher stress amplitudes. Fatigue crack initiation occurred from the specimen surface and crack propagation was characterized by typical fatigue striation together with secondary cracks.