Microstructure and mechanical properties of IN718 on 42CrMo for repair applications by laser directed energy deposition

Abstract

Laser Directed Energy Deposition (LDED) has gained significant attention as a promising additive manufacturing technology for the repair and restoration of worn parts. The objective of this study is to assess the feasibility and performance of repairing 42CrMo substrates using Inconel 718(IN718) powder. In this study, the LDED process was employed to investigate the influence of varying laser power, scanning speed, and feed rate on a single track study. The optimal process parameters for trapezoidal groove repair were determined by comparing and evaluating factors such as dilution, aspect ratio, track continuity, and molten pool shape. Furthermore, the effects of different repair strategies (X-, Y-, Cross-paths) on the microstructure and mechanical properties were investigated. The results indicate that by using suitable process parameters, successful deposition of IN718 on 42CrMo is achieved. The investigation reveals elemental diffusion between the two materials, quenching phase transition on the substrate surface, and the formation of intermetallic compounds in the fusion zone. The fusion zone(FZ) and heat-affected zone(HAZ) exhibited the highest microhardness compared to the substrate. Significant changes in molten pool shape and arrangement were observed using different repair strategies, while the effect on grain size was not significant. Due to the high directionality of the samples fabricated using the LDED process, the samples of the X-path demonstrated the highest ultimate tensile strength and elongation compared to the other two repair strategies. The ultimate tensile strength after repair is comparable to that of the substrate, while the elongation is reduced.