Abstract
(TiH2 + ScH3)/Al-Mg composite powders with different Ti contents were produced by ball milling. These composite powders were fabricated to cube and cuboid shape samples via a laser powder bed fusion process with optimal processing parameters. The TiH2 and ScH3 particles underwent dehydrogenation during the laser powder bed fusion process, and these composite powders ultimately formed Al-Mg-Sc-Ti alloys. The relative density, printability, microstructure, hardness and tensile properties of these alloy samples were investigated. The results show that these Al-Mg-Sc-Ti alloys have lower hot-crack sensitivity, having fine equiaxed grains. An Al18Mg3(Ti,Sc)2 intermetallic phase and in situ L12-Al3(Sc,Ti) precipitations formed during the laser powder bed fusion process, which is beneficial for nucleation and dispersion strengthening. The ultimate tensile strength of the Al-Mg-0.7Sc-1.0Ti alloy was 313.6 MPa with an elongation of 6.6%. During the hot isostatic pressing treatment, most of the Mg element precipitated from the matrix and changed the Al3(Sc,Ti) into a Al18Mg3(Ti,Sc)2 precipitate completely. The Al-Mg-Sc-Ti alloys were nearly fully dense after the hot isostatic pressing treatment and exhibited better mechanical properties. The ultimate tensile strength of the Al-Mg-0.7Sc-1.0Ti was 475 MPa with an elongation of 8.5%.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
