Microstructure and mechanical properties of a high-carbon bainitic steel containing Si/Al by different heat treatment processes

Abstract

The present study aims to investigate the microstructure and mechanical properties of 0.79 C wt% bainitic steel containing Si and Al by three heat treatment processes: austempering and tempering (B-T), two-step austempering (2S-A) and the austempering-quenching-partitioning (AQP). The optical microscope (OM), scanning electron microscope (SEM), X-ray diffraction (XRD), transmission electron microscope (TEM) and electron backscatter diffraction (EBSD) were employed to analyze the microstructure of samples. The results demonstrate that the sample subjected to the AQP process exhibited a multiphase microstructure with martensite, filmy retained austenite (RA) and fine bainitic laths. The AQP sample evidenced a high tensile strength of 1705 MPa, yield strength of 1254 MPa, a better total elongation of 16.6%, product of strength and elongation (PSE) of 28 GPa% and the impact toughness of 33 J among all heat treatment processes. The higher strength and toughness could be ascribed to the fine bainitic ferrite as well as an appropriate amount of filmy retained austenite. A fraction of martensite that was formed during the quenching step at 110 °C possibly divided the untransformed austenite into small areas, which could refine the microstructure. EBSD analysis showed that the AQP sample exhibited a higher proportion (64%) of boundary misorientation angle greater than 15° than that of the 2S-A. These high angle boundaries can improve the toughness of steel.