Microstructure and Element Distribution during Partial Remelting of an Al-4Cu-Mg alloy

Abstract

The effects of the isothermal temperature and holding time on the microstructure and element distribution have been investigated during partial remelting of the semisolid Al-4Cu-Mg alloy. The experimental results show that the optimal process parameter should be chosen at isothermal temperature of 540-580 °C with the holding time of less than 10 min. Coalescence and coarsening of α grains occur at low liquid fraction. At high liquid fraction, coarsening of α grains and melting of small grains were promoted by an increase of the isothermal temperature and the holding time. The coalescence of grains and Ostwald ripening are two main mechanisms of the microstructural evolution during partial remelting. Meanwhile, the higher the isothermal temperature and the longer the holding time, the more segregation of Cu at the grain boundary would be, which conform to the theory of element distribution affected by heating condition.