Abstract
Fe -3.2% Si steel strips were produced using vertical type twin casting process, and the changes of microstructure and texture trough thickness direction were analyzed. The equiaxed grains of approximately 44.6µm were observed in the center layer, the great mass of columnar dendrite was formed near the surface, and the dendrite truck mainly developed in the transverse direction with respect to the casting direction of about 45° or less. From the subsurface to the center, the volume fraction of the Goss texture (110)[001] gradually decreases. The Goss {110} <001> components at the surface are two times those at the center layer, the {001} <100> components are three times those at the center layer, and the overall texture components are similar to that of the hot-rolled oriented silicon steel strip. The minor α texture could be found from the φ2=45° sections of ODF, and there is no remarkable composition segregation of Si element in the thickness direction of thin strip.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.