Abstract
The generation of a high density of twins few tens nanometers in size can enhance both strength and ductility. The present work aims to produce highly twinned microstructure in Cu-6 wt % Zn alloy of a moderate stacking fault energy (SFE) by equal channel angular pressing (ECAP) using a die with angles ϕ= 110° and Ψ = 0. X ray diffraction (XRD) shows that a high density of defects is stored up to 2 passes then a recovery takes place. EBSD imaging reveals a high density of twins and a fibrous microstructure. Grains close to 100 nm in size are formed. Strain rate sensitivity (SRS) was investigated in compression and nanoindentation (NI). Compression curves show that deformation occurs by slipping with a contribution of twins to hardening. A high contribution of shear bands was revealed during ECAP and compression tests. The activation volume V* in compression and NI is in the range 70b3 - 100b3, consistent with the emission of dislocations from grain boundaries and twin boundaries The experimental values of V* were compared to those expected from defect densities.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
