Microstructural origin and control mechanism of the mixed grain structure in Ni-based superalloys

Abstract

Mixed grain structure, as an incomplete recrystallization, should be homogenized and refined by subsequent processing to improve the mechanical properties of the aeroengine components. The microstructural origin and control mechanism is quite necessary for the microstructure homogenizing and grain refining through thermo-mechanical processing. In present research, microstructural origin and control mechanism of the mixed grain structure have been conducted deeply. With the consideration of temperature drop in practical industrial forging, the optimum processing parameters can be determined as 1110–1140 °C/1.0 s−1 to obtain homogeneous equiaxed grains. The microstructure evolution corresponding to the identified optimal parameters, viz., deformation temperature and strain rate, were systematically investigated. Higher dynamic recrystallization (DRX) fraction and coarser DRX grains can be observed at super-solvus temperature deformation (1140 °C). In addition, sub-solvus deformation (1110 °C) shows random orientated distribution while near< 001 > compression texture can be detected in super-solvus deformation. Particular attention was paid to the DRX mechanisms during hot deformation. Discontinuous dynamic recrystallization (DDRX) and continuous dynamic recrystallization (CDRX) occur simultaneously, and the synergistic effect of them contributes to microstructure control. Moreover, DDRX characterized by grain boundary bulging dominants the microstructure control. Progressive subgrain rotation labeled as CDRX can be regarded as an important assistant mechanism. The findings would provide theoretical support for microstructure control of Ni-based superalloys with mixed grain structure, which is of vital importance for components to obtain excellent performance.