Abstract
The present study is concerned with the fabrication and microstructural analysis of boride/Ti-6Al-4V surface-alloyed materials using the irradiation of a high-energy electron beam. Mixtures of TiB2 or MoB powders and CaF2 flux were placed on a Ti-6Al-4V alloy substrate and subsequently irradiated using a high-energy electron beam. Specimens processed with a flux mixing ratio of 40 wt pct showed that the melted region of 1.1 to 1.5 mm in thickness was homogeneously formed without defects and contained a large amount of titanium borides (TiB). The formation of TiB in the melted region greatly improved the Vickers hardness, high-temperature Vickers hardness, and wear resistance to levels 2 or 3 three times higher than the those for the Ti alloy substrate. Also, the addition of MoB powders into the mixtures made possible the fabrication of surface-alloyed materials with various properties by controlling the kind, size, and volume fraction of TiB and the characteristics of the matrix. These findings suggested that surface alloying using high-energy electron-beam irradiation was economical and useful for the development of boride/Ti-6Al-4V surface-alloyed materials with improved properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
