Microstructural evolution and mechanical properties of micro-deformation diffusion bonding Inconel 617 superalloy

Abstract

This study explicates the microstructural evolution and mechanical properties of the Inconel 617 joint, prepared through micro-deformation diffusion bonding. The joints were fabricated with a uniaxial deformation less than 2%. An interface without interfacial voids was achieved when the bonding temperature was increased from 1100 to 1150 °C. The microstructure of the joint devolved at 1150 °C under a holding time of 60 min, comprised of grain boundaries (GB), Cr-rich M 23 C 6 carbides, and α-Al 2 O 3 oxides. The similar microstructure was also observed in the joint prepared at 1150 °C with an incubation time of 180 min. As the bonding temperature was increased to 1180 °C, a continuous network of the M 23 C 6 carbide was nucleated along the bonding interface, accompanied by the grain coarsening, up to 3 times that of pre-bond substrate. The formation of the M 23 C 6 and Al 2 O 3 particles was governed by the diffusion and segregation of Cr, C, Al, and O along the bonding interface. The pinning effect of interfacial precipitates, the M 23 C 6 and Al 2 O 3 particles, inhibited the migration of GB across the bonding interface. The cracks were initiated and propagated along the bond line. The optimum combinations of strength, plasticity, and impact toughness were obtained for the two joint configurations, prepared at 1150 °C with the holding times of 60 and 180 min, respectively. A quasi-cleavage mode of fracture was revealed, consisting of cleavage planes as well as ductile dimples. • The joints of Inconel 617 superalloy were prepared by micro-deformation diffusion bonding. • The microstructural evolution was comprehensively investigated, and its evolution mechanism was elucidated. • The mechanical properties and fracture characteristics of the joints were evaluated.