Abstract
The microstructural evolution of a nickel-based heat resistant alloy during long term aging (10000 h) at 700 °C was systematically investigated. Experimental results showed that the main precipitates after pre-aging treatments were MC, M23C6 and homogeneous γ’. The weight fraction of γ′ increased continuously with the aging time up to 5000 h, while an obvious coarsening was observed after aging for 100 h. The grain sizes of γ′ precipitates from all aged samples exhibited unimodal distributions, and their coarsening behavior showed good agreement with the LSW model. Compared to the MC carbides, the weight fraction of the M23C6 carbides increased significantly with the increase of the aging time. This could be attributed to their precipitation from the supersaturated matrix. Due to the precipitation and coarsening of γ′, the hardness of the aged samples increased sharply during the first 100 h of aging and then decreased with the increase of the aging time (up to 10000 h).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.