Microstructural changes in alkali activated fly ash/slag geopolymers with sulfate exposure

Abstract

Sulfate attack is recognized as a significant threat to many concrete structures, and often takes place in soil or marine environments. However, the understanding of the behavior of alkali-activated and geopolymer materials in sulfate-rich environments is limited. Therefore, the aim of this study is to investigate the performance of alkali silicate-activated fly ash/slag geopolymer binders subjected to different forms of sulfate exposure, specifically, immersion in 5 wt% magnesium sulfate or 5 wt% sodium sulfate solutions, for 3 months. Extensive physical deterioration of the pastes is observed during immersion in MgSO4 solution, but not in Na2SO4 solution. Calcium sulfate dihydrate (gypsum) forms in pastes immersed in MgSO4, and its expansive effects are identified as being particularly damaging to the material, but it is not observed in Na2SO4 environments. A lower water/binder (w/b) ratio leads to a greatly enhanced resistance to degradation by sulfate attack. Infrared spectroscopy shows some significant changes in the silicate gel bonding environment of geopolymers immersed in MgSO4, attributed mostly to decalcification processes, but less changes upon exposure to sodium sulfate. It appears that the process of ‘sulfate attack’ on geopolymer binders is strongly dependent on the cation accompanying the sulfate, and it is suggested that a distinction should be drawn between ‘magnesium sulfate attack’ (where both Mg2+ and SO4 2− are capable of inducing damage in the structure), and general processes related to the presence of sulfate accompanied by other, non-damaging cations. The alkali-activated fly ash/slag binders tested here are susceptible to the first of these modes of attack, but not the second.