Abstract
A comprehensive study was performed on thermoplastic corn starch (TPS)/polystyrene (PS) blend foam to optimize the formulation from the aspects of plasticizer content and the blend ratio. Plasticization of native starch was implemented with various contents of plasticizer [water (W) + glycerol (G)], 21, 23, 25 and 29%, and W/G ratio of 1/2, 2/3, 3/2 and 2/1 using melt extrusion process. The influence of plasticizer loading content and also its combination on the microstructural and physical properties of the blend foam were investigated. The morphological consideration was also carried out by scanning electron microscopy to evaluate the distribution and regularity of the foam cells. The results showed that water had a desirable effect on the cell parameters in W + G = 21 and 29%. In the following, full factorial method in Minitab software was used to optimize the formulation according to the properties. Moreover, the effect of PS content on the moisture absorption and cell structure of TPS/PS blend foam was evaluated. In addition, the blend ratio of 20/80 was obtained as an optimum ratio for the TPS/PS blend foam via evaluating the effect of different contents of PS on the moisture absorption amount and cell structure of the blend foam. The addition of 20% PS to TPS caused to 6 times higher expansion ratio than PS and 60% higher than TPS, while 50% lower moisture absorption than TPS. This combination can be a good alternative candidate for warm food packing applications.
Highlights
In the recent decades, many reports have shown an increased demand for plastic materials in various industrial and medical applications which have direct relationship with human health and the environment [1]
We investigated the impact of various plasticizer contents of water and glycerol at different water/glycerol ratio, and as well as the PS/thermoplastic corn starch (TPS) ratio on the microstructural properties, cell morphology and moisture absorption of the TPS/PS blend foams in continuous extrusion process
TPS/PS blend foam prepared by melt extrusion process was investigated at different plasticizer contents and combinations, and the blend ratio
Summary
Many reports have shown an increased demand for plastic materials in various industrial and medical applications which have direct relationship with human health and the environment [1]. Plastic foams are widely used for diverse targets i.e. cushioning, insulation and warm food packaging [2]. Polystyrene (PS) is one of the most attractive plastics for foam industry, due to its low density, thermal insulation, good mechanical properties and low cost [3]. Starch as a bio-polymeric material from renewable resource attracted the attention of many researchers as a good candidate to alternate or blend with PS [8]. Starch has a low cost biodegradable, and can be used into soil as a compost organic fertilizer [9]
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
