Micro-profiles of activated sludge floc determined using microelectrodes

Abstract

The microbial activity within activated sludge floc is a key factor in the performance of the activated sludge process. In this study, the microenvironment of activated sludge flocs from two wastewater treatment plants (Mill Creek Wastewater Treatment Plant and Muddy Creek Wastewater Treatment Plant, with aeration tank influent CODs of 60–120 and 15–35 mg/L, respectively) were studied by using microelectrodes. Due to microbial oxygen utilization, the aerobic region in the activated sludge floc was limited to the surface layer (0.1–0.2 mm) of the sludge aggregate at the Mill Creek plant. The presence of an anoxic zone inside the sludge floc under aerobic conditions was confirmed in this study. When the dissolved oxygen (DO) in the bulk liquid was higher than 4.0 mg/L, the anoxic zone inside the activated sludge floc disappeared, which is helpful for biodegradation. At the Muddy Creek plant, with its lower wastewater pollutant concentrations, the redox potential and DO inside the sludge aggregates were higher than those at the Mill Creek plant. The contaminant concentration in the bulk wastewater correlates with the oxygen utilization rate, which directly influences the oxygen penetration inside the activated sludge floc, and results in redox potential changes within the floc. The measured microprofiles revealed the continuous decrease of nitrate concentration inside the activated sludge floc, even though significant nitrification was observed in the bulk wastewater. The oxygen consumption and nitrification rate analyses reveal that the increase of ammonia flux under aerobic conditions correlates with nitrification. Due to the metabolic mechanisms of the microorganisms in activated sludge floc, which varies from one treatment plant to another, the oxygen flux inside the sludge floc changes accordingly.