Abstract
Diesel/natural gas dual fuel engine is acquiring more and more attention due to its potential to reduce NOX and soot emission simultaneously. Micro-pilot-induced diesel ignition natural gas engine is a popular manner to further improve the emission reduction capability of dual fuel engine. A six cylinder, four stroke, commonrail diesel engine is converted into dual fuel engine. Natural gas is injected into the intake manifold after the throttle. Five gas injection valves are used to control natural gas flow rate. Based to the established fuel supply system, a dual fuel control system is developed by using MS9S12XEP100 MCU. Voltage boosting circuit, fuel injector driving circuit, gas injection valve driving circuit and MeUn driving circuit are integrated on the platform of MCU hardware. Two ECU is connected to each other by CAN bus and several I/O ports to fulfil the fuel injection functional requirement. A software framework involves gas injection timing synchronization, fuel mode managing, multi-time injection. A MAP based fresh air mass flow rate and intake charge efficiency model is integrated in the MCU to calculate the fresh air quality in cylinder. The last part is performance optimization research at low load. Ignition diesel is divided into two stages, and the first injection timing, first injection ratio and injection pressure are used as controllable parameter to reduce NOX and HC emission. Experimental result reveal that by dividing ignition injection into two stage and advancing first injection to 60°CA BTDC CH4 emission can be reduced by 77% while NOX remains unchanged. Increasing the first injection ratio and injection pressure can also reduce THC emission. If injection pressure is higher than 75MPa, the effect of HC reduction effect is not that obvious. Experimental results shows that developed control system can accomplish the functional requirements of dual fuel engine management. Emission test results demonstrate that IMO TierII can be satisfied at diesel mode. DF mode emission performance can meet the requirement of IMO TierIII. Furthermore, as the first domestic product dual fuel dedicated control system, which has passed through the CCS authentication in China, the engine emission level can meet the current and upcoming China’s emission standard on non-road engine on the premise of guaranteeing engine power and economy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.