Abstract
Abstract We investigate the processing times of ultrafast laser machining in the case of metals (copper and stainless steel). At a fluence of 2.5 J/cm2, measurements of processing times are in good agreement with the calculations based on the ablation rates. We study the influence of laser repetition rates for 1, 5, 10 and 15 kHz. A linear reduction of the processing time can be expected with an increase of the repetition rate.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
