Abstract
Bipolar Proton Exchange Membrane (PEM) fuel cell plates are composed of flat pieces of graphite with channels or trenches machined into the face of the plate so that gases can flow in the channels of the plate. The operation of the fuel cell is dependent on the flow of oxygen and hydrogen gases around a fuel cell stack, which is composed of many thin plates connected to each other in very close proximity. Owing to the brittle nature of graphite, bipolar plates are now made from nickel-chromium alloys that are coated with a thin solid layer of CrN or TiN to improve corrosion resistance. However, nickel-chromium alloys are notoriously difficult to machine. This paper describes the micromachining of fuel cell plates that are machined at very high speeds in order to produce high cutting tool life and low surface roughness using novel nanocrystalline diamond and titanium coatings that have been specifically designed to cut strain-hardening alloys at extremely high speeds.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Manufacturing Technology and Management
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
