Abstract

Abstract The growth kinetics of single crystal lamellae grown from poly(isoprene) melts have been determined by thin film electron microscopy which also reveals the relevant microstructure. The growth rate of a continuous lamellar crystal is independent of the length of the crystal and (in the absence of crosslinks) depends only upon temperature and the chemical composition of the polymer. The temperature dependence is closely similar to that observed for bulk crystallization and spherulite growth, with a maximum crystallization rate around —24° C. The growth rate at a given temperature is extremely sensitive to the chemical composition of the poly(isoprene), being for a polymer containing 10 per cent trans-poly(isoprene) one thousandth of that for pure cis-poly(isoprene). Between these extremes the logarithm of the growth rate decreases linearly with increasing trans content. A similar effect is produced by the introduction of chemical crosslinks instead of trans units. These effects are attributed to a reduction in the probability of formation of the ‘secondary nucleus’, whose size can be calculated from the experimental data. The secondary nucleus is found to correspond to three molecular folds and this agrees well with an independent estimate obtained, by using thermodynamical theory, from the dependence of lamellar thickness on temperature.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.