Abstract
Statement of problemPolyetheretherketone (PEEK) has been increasingly used as a framework material in prosthetic dentistry. However, data on the marginal and internal fit of PEEK restorations fabricated by using either the computer-aided design and computer-aided manufacturing (CAD-CAM) or heat-pressing technique are sparse. PurposeThe aim of this in vitro study was to assess the marginal and internal fit of milled and pressed PEEK single crowns by using microcomputed tomography (μCT). Material and methodsA custom-made, single stainless-steel die was designed to replicate a maxillary first premolar prepared for a ceramic crown. PEEK copings (N=30) were fabricated and allocated to 3 groups (n=10) according to the fabrication technique: milled from a prefabricated PEEK blank, heat pressed from PEEK pellets, and heat pressed from PEEK granules. All copings were veneered with a composite resin material. The marginal fit was recorded at 4 predetermined points and the internal fit at 8 predetermined points on each crown by using μCT. Two-way ANOVA, pair-wise Tukey honestly significant difference (HSD), and simple main effect tests were used for statistical analysis of the data (α=.05). ResultsConcerning marginal fit, the milled crowns demonstrated the best marginal fit overall (44 ±3 μm), followed by those pressed from pellets (92 ±3 μm), and finally by those pressed from granules (137 ±7 μm) (P<.001). The interaction between the effects of the fabrication technique and the measurement point on the marginal fit was not statistically significant (P=.142). The milled crowns demonstrated the lowest mean gap values overall, followed by those pressed from pellets and those pressed from granules (P<.001). The interaction between the effects of the fabrication technique and the measurement point on the internal fit was statistically significant (P<.001). Except for the distal occlusal gap and mesial occlusal gap, all tested groups showed a statistically significant difference (P<.001). In addition, statistically significant differences were observed among all measurement points in different fabrication techniques (P<.001). ConclusionsThe marginal and internal fit of milled PEEK crowns was significantly better than pressed crowns. However, both CAD-CAM and heat-pressing techniques produced PEEK crowns with a clinically acceptable marginal and internal fit. The mean marginal gap of the PEEK crowns pressed from granules was above the range of clinically acceptable value.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.