Abstract
We applied an insulating polymer layer to the surface of mold cavity to injection-mold large plastic parts with a microsized thickness. Polyimide (PI) was coated on the mold wall using spray coating method. A thin light guide plate (LGP) was designed and fabricated via micro-injection molding. The polymeric coating layer could enhance the fluidity of polymer melt in the cavity during filling stage by minimizing the formation of the skin layer during injection molding. The surface roughness and pattern transfer rate of the LGPs were analyzed experimentally. In addition, numerical simulation was carried out to understand the insulation effect of the layer in the injection molding.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
