Abstract
AbstractThe development of micro-air vehicles poses a considerable challenge to the materials scientist. Vehicles that may occupy less than 10cm in any direction require many structural components with dimensions well below 1mm when conventional engineering and assembly techniques are employed. As with conventional unmanned air vehicles (UAVs), and full-scale aircraft, materials that display a huge breadth of characteristics are required to build the airframe and to engineer sub-components, while meeting stringent mass and volume budgets. In particular, high modulus, high toughness, easy formability and jointing are desirable qualities. For larger structures, conventional foamed materials can meet some of these properties. However, the pore sizes in these conventional materials are too large to allow manufacture of micro-scale components, airframe sections and skins. This paper describes the manufacture and properties of some micro-foamed polymers, and polymer composites, metals and oxide ceramics that are being developed at DERA specifically for micro-vehicle applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.