Abstract
Mg-Ca alloy sheets with high toughness and corrosion resistance were developed by tailoring the microstructures of Mg-Ca alloys with Ca contents of ≤1% by means of high-ratio differential speed rolling (HRDSR) followed by annealing treatment. Refinement of Mg2Ca phase to submicron sized particles by HRDSR allowed to achieve a fine-grained recrystallised microstructure with low dislocation density after post-HRDSR annealing. The Mg-0.4Ca and Mg-1Ca alloys had the higher toughness and corrosion resistance compared to the pure Mg. The Mg-0.4Ca alloy exhibited a lower strength than the Mg-1%Ca alloy, but it had a higher ductility and a higher corrosion resistance.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
