Abstract
In order to produce an artificial organ component having a complicated structure, a plastic-forming method was proposed in which small amounts of material were accumulated successively by using a dispenser system manipulated by a robot; a preliminary experiment with silicone rubber was conducted. Components of different shapes were produced, including straight tubes, tapered tubes, bifurcating tubes, tubes having leaflets on the inside, cones, spiral tubes, and tubes with a sack. This method provides the possibility of producing complicated artificial organ components, which are difficult to produce by conventional plastic-processing methods.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
