Abstract
The continuation of the methodology for calculating the technological parameters of the process of constrained extrusion of rectangular brackets under conditions of plane deformation in the general case of misalignment of the punch and die is outlined. The calculation of limiting cases of asymmetric extrusion, which, on the one hand, is reduced to a symmetrical extrusion, and, on the other hand, to a complete overlap of a small outflow gap, is considered. The above formulas make it possible to determine such important parameters of the stamping process as the total and specific deforming forces, as well as the heights of the walls formed as a result of extrusion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
