Abstract

The continuous drive friction welding of aluminum alloy to stainless steel was investigated in this paper. Microstructural characterization, intermetallic compound (IMC), and mechanical properties of the friction welded Al/Fe joint were studied. Results showed that thermal mechanically affected zone (TMAZ) at the Al side was subjected to both thermal cycling and mechanical force, and grain size was 1–3 μm, and streamlines were more dramatically than at the steel side. In fully dynamic recrystallized 127 zone (FDRZ), microstructure became the fine equiaxed grains, and its width at the steel side was about 5 μm. The local Si enrichment IMC layer was formed at the interface area of Al/Fe joint, and its average thickness was about 300 nm. IMC layer was relatively flat at the steel side, while uneven at the Al side. The hardness reached to the maximum value (395.8 HV) at the steel side in FDRZ, and the average hardness was only 76 HV in heat-affected zone (HAZ) at the Al side. When forge pressure was below 220 MPa, the tensile strength of joint was approximately linearly related to the forge pressure.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.