Abstract
The effect of three levels of welding arc energy input on the metallurgical, mechanical, and corrosion behavior of AISI 304L stainless steel was studied with the aim of investigating and recommending the most useful range of process parameters for improved performance of engineering structures made from this industrially important alloy. The gas tungsten arc welding process was employed, and all the joints were butt-welded using a single-V groove design. With an increase in heat input, the δ-ferrite phase changed from lathy to vermicular, besides the heat-affected zones of all the welds exhibiting grain coarsening effects. Postweld thermal aging led to the preferential occurrence of carbides in the interdendritic regions, which degraded their corrosion performance. Thermal aging did not affect the tensile strength of these welds, but their ductility was significantly impacted. The extent of segregation of Cr and C, especially, was observed to be the least in the case of low heat input welds. This study establishes that while designing welding procedures for AISI 304L structures, low welding arc energy should be used as it promotes better mechanical as well as corrosion properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.