Abstract
Aluminium matrix composites (AMCs) having more than one reinforcement (hybrid AMCs) found enlarged use due to better strength, high thermal stability and wear resistance properties and can be a substitute for single reinforced AMCs .The effect of varying ball milled (BM) B4C/Si3N4 particles on the microstructure of as cast AA6082 and mechanical properties of AA6082 alloy hybrid composites produced by combined ball milling and conventional stir casting method have been reported. The combined reinforcement of BM B4C/Si3N4 particles were varied from 0-9 % in a step of 3. The wettability of B4C/Si3N4 into the aluminium melt has been increased by ball milling the boron carbide with silicon nitride powder, so that combined reinforcement of B4C/Si3N4 neither float nor sink in the aluminium melt. The investigated result showed that addition of combined reinforcement of BM B4C/Si3N4 increased Hardness and Ultimate tensile strength at the cost of reduction in percentage elongation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.