Abstract
A novel proof-of-concept prototype Mesoscale Actuator Device (MAD) containing microscale components has been developed. The MAD is similar to piezoelectrically driven inchworm motors with the exception that mechanically interlocking microridges replace the traditional frictional clamping mechanisms. The interlocked microridges, fabricated from single crystal silicon, are designed to increase the load carrying capability of the device substantially. Tests conducted on the current design demonstrate that interlocked microridges fabricated with 30% KOH solution support a 9.6 MPa shear stress or that a pair of 5×5 mm locked chips supports a 500 N load. For high frequency operation, an open loop control signal is implemented to synchronize the locking and unlocking of the microridges with the elongating and contracting of the actuator. The system was successfully operated from 0.2 Hz to 500 Hz (or speeds from 2 μm/s to 5 mm/s). The upper limit (500 Hz) is imposed by software and hardware limitations and not related to physical limitations of the prototype device.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
