Abstract
PurposeThe purpose of this study is to find a new design that can increase the sensitivity of the sensor without sacrificing the linearity. A novel and very efficient method for increasing the sensitivity of MEMS pressure sensor has been proposed for the first time. Rather than perforation, we propose patterned thinning of the diaphragm so that specific regions on it are thinner. This method allows the diaphragm to deflect more in response with regard to the pressure. The best excavation depth has been calculated and a pressure sensor with an optimal pattern for thinned regions has been designed. Compared to the perforated diaphragm with the same pattern, larger output voltage is achieved for the proposed sensor. Unlike the perforations that have to be near the edges of the diaphragm, it is possible for the thin regions to be placed around the center of the diaphragm. This significantly increases the sensitivity of the sensor. In our designation, we have reached a 60 per cent thinning (of the diaphragm area) while perforations larger than 40 per cent degrade the operation of the sensor. The proposed method is applicable to other MEMS sensors and actuators and improves their ultimate performance.Design/methodology/approachInstead of perforating the diaphragm, we propose a patterned thinning scheme which improves the sensor performance.FindingsBy using thinned regions on the diaphragm rather than perforations, the sensitivity of the sensor was improved. The simulation results show that the proposed design provides larger membrane deflections and higher output voltages compared to the pressure sensors with a normal or perforated diaphragm.Originality/valueThe proposed MEMS piezoelectric pressure sensor for the first time takes advantage of thinned diaphragm with optimum pattern of thinned regions, larger outputs and larger sensitivity compared with the simple or perforated diaphragm pressure sensors.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have