Abstract
Superhydrophilic oil–water separation membranes were prepared based on chemical (non-photo-induced) polymerization of acrylamide on metal meshes. Membranes were characterized by surface morphological analysis (SEM and AFM), determination of contact angles of water and oil drops, measurement of water flow through the membranes, analysis of dissolved organic in filtered water–oil systems, critical intrusion pressure of oil and surface coverage by bacterial biofilms. The main characteristics of the membranes were studied as function of coverage with polyacrylamide (PAM). The membranes presented efficiencies larger than 99% for toluene-water separation and lifetimes of several months. The intrusion pressure (0.25–1.25 kPa) and water flux (10–300 Lm-2s−1) varied depending on PAM coverage. A mathematical model was implemented for predicting the water flow as function of hydrogel coverage.The results indicate there is a degree of compromise between three factors that are related to the amount of PAM coating: avoiding biofouling (which can block the flow, induce corrosion, etc.), maintaining an important flow of water and sustaining a given intrusion pressure of oil on the membranes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.