Abstract
Seeking an energy efficient and environmentally friendly technology for CO2 capture could be promising for reduction of CO2 emissions. Membranes have already been commercially used for selected gas separations and have potential to be used for CO2 capture. However, process and economic feasibility of membrane separation system significantly depends on not only membrane materials but also process operating conditions. Thus, membrane system design by process simulation was conducted in this work. A single stage membrane unit was designed to accomplish specific separation requirements of >80% CO2 capture ratio at a maximum acceptable membrane area 600,000m2. The obtained characteristic diagrams showed that a minimum membrane performance of CO2 permeance 2m3(STP)/(m2hbar) and CO2/N2 selectivity 135 should be achieved at a stage-cut of 15.2% and a feed and permeate pressure of 2.5bar and 250mbar, respectively. A two-stage membrane system using high performance fixed-site-carrier membranes by integration of compression heat was designed to achieve >80% CO2 capture ratio and >95% CO2 purity from a 18,260kmol/h flue gas in a refinery. The simulation results showed nice potential for CO2 capture with a specific energy consumption of 1.02GJ/ton CO2 and a capture cost of 47.87$/ton CO2 captured.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.