Membrane role in heat and mass transfer resistance distribution and performance of hollow fiber membrane contactor for SGMD desalination

Abstract

Hollow fiber membrane contactor (HFMC) is the core device of heat mass exchange between seawater solution and sweeping air in sweeping gas membrane distillation (SGMD) desalination. In order to reveal the distribution of heat and mass transfer resistance on feed solution side, porous membrane side and sweeping air side, a mathematical model considering the simultaneous heat mass transfer and water vapor diffusion mechanism in the membrane pores was established for the cross-flow HFMC. The simulation results of the model were compared with experimental results and literature results. Comparison shows that the deviation of simulation results of the model is less than 13.4 %, which verifies the accuracy and reliability of the simulation results. Influences of the main structural characteristics of porous membrane on the resistance distribution of heat and mass transfer, efficiency and membrane flux were explored. Air side dominates the heat transfer process, while the membrane side accounts for less than 39 % of the total heat transfer resistance for the main range of membrane microstructure parameters investigated. The mass transfer is controlled by the porous membrane except for thin membrane with a thickness of less than 100 μm. Membranes with porosity above 0.8 and as thin as possible can achieve better mass transfer efficiency and freshwater flux. Increasing mean pore diameter has a strong promotion effect on the increase of membrane flux before it reaches 150 nm, and beyond this critical value, the water vapor diffusion mechanism changes from Knudsen collision to molecular collision. Effects of different operating parameters and membrane microstructure parameters on air temperature distribution and humidity distribution were also analyzed.