Abstract
Conductive materials with attached biofilms, were used as membrane filtration biocathodes to filter the effluent and supply electrons for denitrification. Stainless steel mesh and carbon felt were employed to fabricate membrane modules, and the two MFC systems were termed as M1 and M2, respectively. High effluent quality was obtained with M1 and M2 in terms of turbidity, COD and ammonium. In M1, no bioelectrochemical denitrification took place, while nitrate decreased from 35.88±4.15 to 27.33±5.32mg-N/L through the membrane in M2, causing a removal efficiency of 23.3±6.5% with respect to cathodic nitrate. The denitrification ceased without electricity. The maximum power densities of M1 and M2 were 121 and 1253mW/m3, respectively. Micrococcus bacteria and rod-shaped bacteria covered the surface of carbon felt and fewer bacteria were found on stainless steel mesh. According to fluorescence in situ hybridization, the putative bacteria affiliated with Paracoccus genus and Pseudomonas spp. dominated in the interior biofilm on carbon felt for denitrification. Results demonstrate that the carbon felt system can perform bioelectrochemical denitrification to polish the effluent.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
