Membrane evaluation for the treatment of acidic clear filtrate

Abstract

The total effluent load of a paper mill can be significantly decreased by recycling of purified clear filtrate (CF) back to paper-making process. The CF treated with membranes can be reused, for instance, as wire section shower water and in the dilution of chemicals. The main requirements for a membrane in CF treatment are high filtration capacity, high retention of turbidity and low fouling tendency. Previous studies have shown that the regenerated cellulose (RC) ultrafiltration (UF) membrane C30F (current trade name UC030T) is especially suitable for the treatment of paper mill process waters. Every paper-making process is, however, different. Thus, filtration experiments are required in order to find the most optimal membrane for the treatment of a certain process water. In this study the best membrane for the treatment of acidic clear filtrate (ACF) was searched. The performance of the C30F membrane was compared with five UF and three microfiltration (MF) membranes. The results revealed that in addition to the C30F membrane, also some other membranes produced high filtration capacity with ACF (approximately 200 L/(m 2h bar)). All the tested membranes also retained over 90% of turbidity. The extremely hydrophilic C30F membrane had, however, lower fouling tendency compared to the other tested membranes. Therefore, it was concluded that the C30F membranes were the best possible membrane for the ACF treatment.