Abstract
ABSTRACTThe heat treatment conditions are a key factor in fabricating zirconolite ceramics and glass-ceramics following high-temperature melting. An oxide mixture melted at 1450°C and subsequently heat-treated at 1200°C yielded a glass-ceramic containing crystallized zirconolite–2M. The silica-enriched residual glass represented about 60-70 vol% of the total; the actinide surrogates (Nd, Ce)were equally distributed between the residual glass and the zirconolite crystals. Zirconolite ceramics obtained after melting an oxide mixture at 1600–1700°C consisted of zirconolite, perovskite and rutile. Rapid cooling rates (> 100°#x00B0;··min-1) were obtained by pouring the melt into ingot molds; the resulting zirconolite ceramics were characterized by crystals of zirconolite-2M ranging from 1 to no more than 20 μm. Slow cooling (< 25°C#x00B0;··min-1 produced ceramics with crystals several hundred micrometers long. Despite the microstructural differences, the chemical durability of the zirconolite ceramics was identical. The initial alteration rates r0 were about two orders of magnitude lower than those measured for the residual aluminosilicate glass of the zirconolite glass-ceramics. Moreover, during long-term leach tests at high S/V ratios to obtain advanced degrees of reaction progress, the alteration rates of all the materials diminished by over 3 to 4 orders of magnitude below r0.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
