Abstract
ABSTRACTThe melt spinning flow behaviour of a high-density polyethylene (HDPE) blended with a low-density polyethylene (LDPE) was studied using a melt spinning technique in temperature ranging from 160 to 200°C and die extrusion velocity varying from 9 to 36 mm s−1. The results showed that the melt apparent extension viscosity of the blends was higher than those of the LDPE and HDPE; the melt apparent extension viscosity decreased with increasing temperature; while the melt apparent extension viscosity increased with increasing extension strain rate when the extension strain rate was lower than 0.2 s−1, and then decreased; the melt apparent extension viscosity reached up to a maximum value when extension strain rate was about 0.2 s−1; the relationship between the melt apparent extension viscosity and the LDPE weight fraction did not follow the mixing rule.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.